7.6 Power balance
data from your
dual-sided
powermeter is not
shown on ANT+
display unit
• Ensure your powermeter is configured to dual-sided
mode (see Section 2.4.1)
• Ensure your ANT+ display unit is connected to the ANT+
ID shown on your 4iiii App, this ANT+ ID is also shown on
the non-drive side powermeter housing
7.7 Cannot
connect
PRECISION PRO to
ANT+ display unit
• Spin the crank arms four times to wake your powermeter
• Ensure the powermeter is paired with
your ANT+ display unit
• Remove the battery from your powermeter, wait one
minute, and put the battery back in your powermeter
• Replace battery in your powermeter
(see Section 2.3)
• Connect to your ANT+ display unit using the ANT+ ID
on the left crank arm
7
TROUBLESHOOTING
25
Table of Contents
To Next Page
