4titude 4s3 - Warnings; Personal Injury Precautions; Electric Shock Prevention; Product Damage Avoidance

4s3™ Semi-Automatic Sheet Heat Sealer
4s3™ Semi-Automatic Sheet Heat Sealer, Operation Manual V1.0
Warnings
Personal Injury
• Do not use this product in a manner other than as stated in the Operating Conditions section of this manual as
the protection provided by the equipment may be impaired.
• This product is designed for use in laboratory environments by persons knowledgeable in safe laboratory
practices.
• Always wear safety glasses and other appropriate protective equipment when operating this product.
Electric Shock
• This product must be connected to a grounded power outlet for safe functioning.
• Use only the power cord supplied with the product.
• The power cord is the device available for full disconnect from mains input.
• Position the product for use so that the power cord can be easily disconnected without having to move the
product.
• Disconnect the power cord before moving or cleaning the unit.
Product Damage
• Keep the product dry and clean.
• Do not immerse the product in liquid for cleaning.
• This unit is not explosion or spark proof.
• Do not operate this product near volatile or ammable materials.
General Operation Safety
• When using infectious, radioactive, toxic and other solutions which may pose health risks, please observe the
appropriate safety precautions.
• Do not use this machine in a potentially explosive environment or with potentially explosive chemicals.
• Install the machine in a location free of excessive dust.
• Avoid placing the machine in direct sunlight.
• Choose a at, stable surface capable of withstanding the weight of the machine.
• Install the machine in the room temperature 10 ‒ 30˚C, relative humidity 0 ‒ 85%.
• Do not block the air vents.
• Make sure the power source conforms to the required power supply specications.
• To avoid electric shock, make sure the machine is plugged into a grounded electric outlet.
• Do not allow water or any foreign objects to enter the various openings of the machine.
• Switch off the power switch before cleaning or performing any service on the machine, such as replacing the
fuses.
• To guarantee sufcient ventilation, ensure that the sealer has at least 30 cm of free space on all sides, including
the rear.
• Repair should be carried out by authorized service personnel only.
• Use original spare parts and accessories only.