iii
Use the monitor safely and correctly.
Connect all cables correctly and securely.
Do not place objects on the monitor or power cable.
Using other devices in conjunction with this monitor may cause incorrect
diagnosis or safety problems. When used, check for safety.
Always use accessories and consumables approved by A&D.
Carefully read the instruction manuals provided with optional items.
The precautions for these items are not listed in this manual.
For safe and correct use of this monitor, always perform a pre-inspection
inspection before use).
If the monitor is covered with condensation, allow it to dry before switching
the power on.
If the monitor has not been used for an extended period, check that the
monitor operates normally and safely before using it.
The pressure of the cuff may cause a patient’s arm to become numb.
3. When using the monitor.
Do not use a mobile phone near the monitor. It may cause a malfunction.
Do not use the monitor in a moving vehicle as this may result in inaccurate
measurements.
Do not use the device where flammable gases, such as anesthetic gases,
are present. It may cause an explosion.
Always check the condition of the monitor, its parts and the patient for safety.
If a problem is found with the monitor, its parts or the patient, stop using the
monitor, check the status of the patient and take appropriate actions.
Frequent measurements can cause injury to the patient by interfering with
blood flow.
Check the condition of the patient on a regular basis if measurements are
performed frequently for a long time. There is a risk of causing damage by
interfering with blood flow.
To ensure accurate measuring, we recommend measuring blood pressure
after being in a relaxed state for at least five minutes.
To Next Page
Loading...
