iv
4. After using the monitor.
Do not forcibly pull out the cables. Hold the connector with your hand when
disconnecting the cables.
Use the specified procedure to return switches to their state before usage,
then switch the power off.
Clean the accessories and arrange them before storage.
Keep the monitor clean and in proper operating condition so that it can be
used without problem for the next operation.
5. If you suspect there is a problem with the monitor, perform the
following actions.
Ensure the safety of the patient.
Stop the operation of the monitor, switch the power off, and then disconnect
the power cable from the outlet.
If the air in the cuff is not released by pressing the START/STOP switch,
press the FAST STOP switch.
Label the monitor with a sign that says "Out of order" or "Do not use" and
then contact A&D immediately.
6. When performing a maintenance inspection.
For your safety, before performing a maintenance inspection, switch the
power off and disconnect the power cable from the outlet.
Always perform a pre-
inspection and maintenance inspection to ensure safe
and correct operation. The organization that installs the monitor (hospital,
clinic) is responsible for use, maintenance, and management of medical
electrical devices. Neglecting pre-inspection and maintenance inspection
Never disassemble or modify the monitor (medical electrical device).
When maintaining the monitor, use a dry, soft cloth. Do not use rags soaked
in volatile liquids such as thinner and benzene.
To Next Page
Loading...
