Installation and First-Time Operation
78
eud-0830/2.0 — I7.6 — 08.2007
n
Wall mounting
You can also mount the phone on the wall. To do so, screw the stand rest onto the wall as a
bracket and hook the phone onto the stand rest.
• Fit the screws for securing the stand rest and mount the stand rest (Figure A).
• Connect the handset cord and the phone cod to the phone (Figure B). For the correct con-
nection assignment refer to the Chapter "Connecting the Office 70", page 79 resp. "Connect-
ing the Office 70IP", page 80
• Insert the phone into the stand rest horizontally (Figure C-1) and slide downwards (Figure C-2).
• Unscrew the cams for holding the handset (Figures D-1 to D-3).
• Insert the handset.
Notes:
• As there is only a limited amount of space between the sockets on the back of the phone and the wall
on which it is mounted, you need to use a ribbon cable with a short connector for the cord. Ask your
dealer for a list of suppliers for a suitable ribbon cable (only Office 70IP).
• You can only connect one Office KBM resp. one Office DKBM expansion key module (option) if the
phone is wall-mounted.
1
2
1
2
3
A
B
C
D
151 mm
145 mm
130 mm
65 mm
3.5 mm
eud-0830_en.book Page 78 Monday, August 13, 2007 3:01 PM
To Next Page
Loading...
