Personalizing Your Phone
66
eud-0830/2.0 — I7.6 — 08.2007
n
Clearing a Key
You want to clear the assignment made to a configurable key.
The No function function is provided specifically for this purpose.
Configuring Line Keys
This section explains how to adapt your Line key settings to suit your personal requirements.
Your system administrator will determine whether your phone has Line keys.
n
Setting the Response of a Line Key
You want to set the response of a Line key in case you are called on that Line key.
You can choose whether you also want a ringing signal in addition to the flashing Line key
when you receive a call on a Line key. You can configure a ringing delay for the ringing tone.
To answer a call you can choose between answering directly by pressing the Team key, picking
up the handset, and using automatic hands-free operation.
Answering an external call using automatic hands-free operation is not available.
The following audio settings are possible: Ringing, Melody, Speed, Answer.
To find out how to use a line key, refer to the Chapter "Phoning over a Line Key", page 47.
<long>
To clear a configurable key:
Press the configurable key and hold it down for a moment.
Þ
The display shows the key type.
<long>
To clear the Foxkey:
Press the Foxkey with a long keystroke.
Þ
The display shows the key type.
No function
Scroll to No function and confirm Ok with the Foxkey.
Þ
The key configuration is cleared.
Notes:
• A line key can only be allocated to a configurable key.
• If you want to use a Line key under a configurable key of the Office DKBM expansion key module, it is
advisable to store it on level 1.
eud-0830_en.book Page 66 Monday, August 13, 2007 3:01 PM
To Next Page
Loading...
