Aastra OpenCom 100 series - Call Forwarding After Delay; Call Forwarding for Other Users

Forwarding Calls
19
6.3 Call Forwarding “After Delay”
For internal and external calls
On:
H*61* (external access code, e.g. 0) Z (destination no.) #
Off:
H#61#
Only for internal calls
On:
H*611* (external access code, e.g. 0) Z (destination no.) #
Off:
H#611#
Only for external calls
On:
H*612* (external access code, e.g. 0) Z (destination no.) #
Off:
H#612#
Calls (only internal, only external or both types) are signalled at the selected ter-
minal and after the time set in the OpenCom 100, these calls are forwarded to
another specified terminal.
6.4 Call Forwarding for Other Users
In order to program call forwarding for call numbers of other users, you must have
the “Call forwarding for other user” authorisation. Also, you can only configure call
forwarding only for those users whose terminal have not been blocked for this
type of access (these users will themselves have the authorisation “Prevent call for-
warding by other user”). Please consult your system administrator if you have
questions regarding these authorisations.
Call forwarding for call numbers of other users always apply for internal and
external calls.
Immediately
On:
H*214* Z (user’s internal tel. no.) *Z (destination no.) #
Off: H#214* Z (user’s internal tel. no.) #
Calls for the user will immediately be forwarded to the other terminal. When the
user pick ups their headset they hear the special dialling tone.