Remote-Controlled Functions
32
9.4 Deleting All Call Forwarding in the Exchange
H*184 Z (system PIN) #
Call forwarding can be set up in the network operator’s exchange. For setting up
new call forwarding or finding faults, it can be useful to delete all active call for-
warding in the exchange. Using the above code-number procedure, you can do
this from any telephone.
Deleting the call forwarding in the exchange is a background function. After you
entered the procedure this process will take time (up to 15 seconds for each line).
Please have patience with this.
The system PIN is issued by the system administrator. It must have been changed
from the factory setting “0000” valid on delivery to another value.
10. Remote-Controlled Functions
The OpenCom 100 enables remote-controlled calls and remotely programmable
call forwarding. These features are set up by the system administrator when he
configures the system. To carry out these features the system PIN is required.
The system PIN is issued by the system administrator, who has to change the
default value “0000” to another value before it is issued.
In addition, all the owners of voiceboxes can, with the corresponding authori-
sation, call their voiceboxes from external telephones. They can remotely access
and edit their messages as well as modify the central settings of their voiceboxes.
10.1 Remote-Controlled Dialling (Call Through)
Without internal number assignment
Z (reserved tel. no.)
Wait until the connection to the communications system has been established.
You hear a positve acknowledgement tone.
Z (system PIN) *(external access code, e.g. 0)
Z (external tel. no.) #
To Next Page
Loading...
Need help?
General
