Maintenance (Continued)
i-STAT Alinity v — User Manual 650-7100 Rev. A42
Sensitive Areas Avoid forcing liquid into these areas:
WIPE
3
X
3
X
3X 3X
Disinfecting (Cont.)
Base Station, Electronic Simulator and Printer
Remove a wipe from the container
and squeeze out any excess fluid
before you begin to wipe the
surface.
Wipe with gauze
until dry.
Allow all surfaces
to remain wet
for 3 minutes.
1
3 4
2
Wipe the front as shown, flip products
on back side and repeat.
Wipe 3X
Left & Right
Wipe 3X
Up & Down
Base Station
10-Pin Connector
Gold contact pins (2)
USB Port
Electronic Simulator
Area between protective cap
retaining ring and white sensor area
B
A
C
A
B
C
D
To Next Page
Loading...
