Abaxis i-STAT Alinity v - Wired Network Connection Setup

i-STAT Alinity v — User Manual 650-7100 Rev. A66
AlinIQ NCi - Wired Network Connection
I want the i-STAT Alinity v Analyzer to connect to my facility’s WIRED
network
To configure connectivity for a wired network, select this check box and
specify values for:
Authentication Type
OPEN (this value is not modifiable)
IP Address Mode
Select one of these values:
• Automatic (DHCP) - Obtain IP addresses and networking parameters
automatically from a DHCP server.
• Use the following IP Address - Select this button to use a static IP
address.
If you specify a static IP address you must also specify DNS addresses.
IP Address
IPv4 address of analyzer in decimal dot notation.
Subnet Mask
IPv4 mask that defines the Subnet in decimal dot notation.
Default Gateway
IP address for routing device that passes trac between dierent subnets
Connectivity (Continued)
4A
4B
4C
4D
4E
4F