ABB 650 series - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction.......................................................................5
This manual........................................................................................ 5
Intended audience.............................................................................. 5
Product documentation.......................................................................6
Product documentation set............................................................6
Document revision history............................................................. 7
Related documents........................................................................7
Symbols and conventions...................................................................8
Symbols.........................................................................................8
Document conventions.................................................................. 8
Functions included in 650 series IEDs.......................................... 9
Section 2 Engineering tool set........................................................15
Introduction.......................................................................................15
IED engineering process.................................................................. 16
Section 3 Engineering process.......................................................19
Workflow...........................................................................................19
Section 4 Setting up a project........................................................ 23
PCM600 operates on projects.......................................................... 23
Installing Connectivity packages...................................................... 23
Setting technical key.........................................................................24
Setting up communication between PCM600 and the IED...............26
Project managing in PCM600...........................................................31
Building a plant structure.................................................................. 33
IEC 61850 naming conventions to identify an IED...................... 34
Inserting an IED................................................................................35
Setting IED IP address in the project...........................................46
Section 5 Protection and control engineering................................ 49
Creating an application configuration with ACT................................49
Overview......................................................................................49
Function blocks............................................................................50
Signals and signal management................................................. 52
Function block execution parameters..........................................52
Configuration parameters............................................................ 55
Connections and variables.......................................................... 55
Hardware channels......................................................................56
Validation.....................................................................................57
Table of contents
650 series 1
Engineering manual