ABB AC 31 - 5.7.3. TP: monostable (constant); 5.7.4. TIME_W:; 5.7.5. W_TIME:

Programming
ABB Control - AC 31 Page 5-39
1SBC 260400 R1001-b 06.99
5.7.3. TP: monostable (constant)
This block enables the activation of an output during a fixed time as from the moment when a
rising edge appears on the input. A new rising edge will not be taken into account if it appears
on the input before the timer time has been completed.
TP
IN
PT
Q
ET
%I62.00
%KD001.00
%O62.00
%MD000.00
Q
PT
IN
PT
5.7.4. TIME_W:
The function TIME_W can be used to display elapse time on the display extension XTC 08
5.7.5. W_TIME:
The function W_TIME is needed when the time value has to be modified during program (i.e.
Control panel, supervisor, set point validation…)
TIME_W
TIME
H
MN
SEC
MS
%OW63.00
%OW63.01
%OW63.02
%OW63.03%MD000.00
W_TIME
H
MN
SEC
MS TIME
%OW63.00
%OW63.01
%OW63.02
%OW63.03 %MD000.00
TON
IN
PT
Q
ET
%MD000.00
%I62.00 %O62.00
%MD000.01