Controller configuration via terminal program Section 7 Commissioning
100 M&I – AC 900F Controller
The 255.255.255.255 broadcast address and the 0.0.0.0 address are special cases
and cannot be set. In case of an invalid entry, the boot loader repeats this
configuration item.
Subnet mask
There is a subnet mask for each Internet address. Contact your network
administrator for the mask that corresponds to your Internet address.
The subnet mask is entered as described for the Internet address.
Default router
If a default router for communication with remote operator stations is installed in
your network, the corresponding Internet address can be entered here.
Data transmission rate, duplex mode and redundancy
The controller supports 10 MBit/s (10BASE-T) and 100 MBit/s (100BASE-TX) in
half duplex and full duplex mode. Upon selection of Auto negotiation, the controller
independently negotiates the data transmission rate and the duplex mode with the
remote station.
ETH1.
Enter subnet mask: [255.255.240.0]
Enter default router IP address: [0.0.0.0]
Set Ethernet link 1 configuration:
0. Auto negotiation
1. 100 MBit full duplex
2. 100 MBit half duplex
3. 10 MBit full duplex
4. 10 MBit half duplex
Select: [0]
To Next Page
Loading...
