ABB ACH580-01 Series - Install Optional Modules, if any; Install Side Plates and Covers

EN – R6…R9 Quick installation guide 39
R0-
R3
R6-
R9
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
Install optional modules, if any
See chapter Electrical installation in ACH580-01 hardware manual
(3AUA0000076331 [English]).
Install side plates and covers
See figure R6…R9 Figures E on page 44.
IP21
1. Reinstall the side plates of the cable entry box. Tighten the retaining screws with a
screwdriver.
2. Slide the cover of the cable entry box on the module from below until the cover
snaps into place.
3. Reinstall the module cover. Tighten the two retaining screws with a screwdriver.
IP55
1. Reinstall the module cover. Tighten the two retaining screws with a screwdriver.
For start-up instructions, see chapter EN – Quick start-up guide on page 49.