General safety in installation, start-up and maintenance
These instructions are for all personnel who do work on the drive.
WARNING!
Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
• Keep the drive in its package until you install it. After unpacking, protect the drive
from dust, debris and moisture.
• Use the required personal protective equipment: safety shoes with metal toe cap,
safety glasses, protective gloves and long sleeves, etc. Some parts have sharp
edges.
• Lift a heavy drive with a lifting device. Use the designated lifting points. See the
dimension drawings.
• Incorrect lifting can cause danger or damage. Obey the local laws and regulations
applicable to lifting, such as requirements for planning the lift, for capacity and
condition of lifting equipment, and for training of personnel.
• Attach the drive cabinet to the floor to prevent it from toppling over. The cabinet has
a high center of gravity. When you pull out heavy components or power modules,
there is a risk of overturning. Attach the cabinet also to the wall when necessary.
• Do not stand or walk on the cabinet roof. Make sure that nothing presses against
the roof, side or back plates or door. Do not store anything on the roof while the
drive is in operation.
• Do not use the module extraction/installation ramp with plinth heights which exceeds
the maximum allowed height. See the technical data.
• Attach the module extraction/installation ramp carefully.
• Make sure that the module does not topple over when you move it on the floor: Open
the support legs by pressing each leg a little down and turning it aside (1, 2).
Whenever possible attach the module also with chains. Do not tilt the drive module.
18 Safety instructions
To Next Page
