5
Mechanical installation –
Frames R4 and R5
Contents of this chapter
This chapter describes how to install drive frame sizes R4 and R5 with the flange
mounting kit mechanically.
Unpacking and examining the delivery
￭
Transport package contents
The flange mounting kit package is tied with straps onto the drive package or sent
separately. Examine that all items are present and there are no signs of damage.
Read the data on the type designation label of the drive to make sure that the
drive is of the correct type.
To unpack:
• Cut the straps.
• Remove the flange mounting kit package. For the contents of the kit package,
see Flange mounting kit package contents (page 34).
• Remove the drive cardboard box and option box.
• Remove the cover protecting film. For the contents of the drive package, see
the drive hardware manual.
• Lift the drive.
Mechanical installation – Frames R4 and R5 33
To Next Page
Loading...
