398 Parameters
60.19 M/F comm
supervision sel 1
Parameters 60.19…60.28 are only effective when the drive is
the master on a D2D (drive-to-drive) link, implemented by
application programming. See parameters 60.01 M/F
communication port and 60.03 M/F mode, and Drive
(IEC 61131-3) application programming manual
(3AUA0000127808 [English]).
In the master, parameters 60.19 M/F comm supervision sel 1
and 60.20 M/F comm supervision sel 2 specify the followers
that are monitored for loss of communication.
This parameter selects which followers (out of followers
1…16) are monitored. Each of the selected followers is polled
by the master. If no reply is received, the action specified in
60.09 M/F comm loss function is taken.
The status of communication is shown by 62.37 M/F
communication status 1 and 62.38 M/F communication status
2.
-
0000h…FFFFh Selection of followers for D2D communication supervision (1). 1 = 1
60.20 M/F comm
supervision sel 2
Selects which followers (out of followers 17…32) are
monitored for loss of communication. See parameter 60.19
M/F comm supervision sel 1.
-
0000h…FFFFh Selection of followers for D2D communication supervision (2). 1 = 1
No. Name/Value Description Def/FbEq16
Bit Name Description
0 Follower 1 1 = Follower 1 is polled by the master.
1 Follower 2 1 = Follower 2 is polled by the master.
…… …
15 Follower 16 1 = Follower 16 is polled by the master.
Bit Name Description
0 Follower 17 1 = Follower 17 is polled by the master.
1 Follower 18 1 = Follower 18 is polled by the master.
…… …
15 Follower 32 1 = Follower 32 is polled by the master.
To Next Page
Loading...
