40 Mechanical installation
Examining the installation site
The drive modules can be installed tightly side by side.
Make sure that the installation site agrees with these requirements:
• The installation site has sufficient ventilation to prevent overheating of the drive.
See section Losses, cooling data and noise in the hardware manual.
• The operation conditions of the drive agree with the specifications in section
Ambient conditions in the hardware manual.
• The mounting plate is vertical, not flammable and strong enough to hold the
weight of the drive module. See section Necessary tools on page 40.
• The material below the installation is not flammable.
• There is enough free space above and below the drive for cooling air flow, service
and maintenance. See pages 36 and 72. There is enough free space in front of
the drive for operation, service and maintenance.
Necessary tools
• Drill and drill bits
• Screwdriver and/or wrench with bits.
Moving the drive module
Move the transport package by pallet truck to the installation site.
To Next Page
Loading...
