Electrical installation 51
Installing the drive module shelves and connecting the
cables – ACS880-01 frames R1 and R2
1. Go through steps 1 to 9 in section Power cable connection procedure (IEC) on
page 49.
2. Attach the mechanical support self for the power cables to the drive module.
3. Connect the twisted shields of the power cables to the grounding terminals.
4. Connect the phase conductors of the input cable to the L1, L2 and L3 terminals
and the phase conductors of the motor cable to the T1/U, T2/V and T3/W
terminals. Connect the brake resistor conductors (if present) to the R+ and R-
terminals. Tighten the screws to the torque given in the figure below.
5. Install the shelves for grounding the additional PE conductor of the input cable
and the pair-cable shields and grounding wires of the control cables.
6. Connect the additional PE conductor of the input cable to the grounding shelf.
7. Go to section Connecting the control cables – ACS880-01 frames R1 and R2 on
page 54.
To Next Page
Loading...
