ABB ACS880-17 - Page 116

116 Parameters
43 Brake chopper Settings for the internal brake chopper. 326
44 Mechanical brake control Configuration of mechanical brake control. 328
45 Energy efficiency Settings for the energy saving calculators. 332
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
335
47 Data storage Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
339
49 Panel port communication Communication settings for the control panel port on the drive. 342
50 Fieldbus adapter (FBA) Fieldbus communication configuration. 344
51 FBA A settings Fieldbus adapter A configuration. 352
52 FBA A data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
353
53 FBA A data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
354
54 FBA B settings Fieldbus adapter B configuration. 354
55 FBA B data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
355
56 FBA B data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
356
58 Embedded fieldbus Configuration of the embedded fieldbus (EFB) interface. 356
60 DDCS communication DDCS communication configuration. 364
61 D2D and DDCS transmit
data
Defines the data sent to the DDCS link. 377
62 D2D and DDCS receive
data
Mapping of data received through the DDCS link. 381
90 Feedback selection Motor and load feedback configuration. 389
91 Encoder module settings Configuration of encoder interface modules. 398
92 Encoder 1 configuration Settings for encoder 1. 401
93 Encoder 2 configuration Settings for encoder 2. 407
94 LSU control Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
407
95 HW configuration Various hardware-related settings. 411
96 System Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection; data logger triggering; parameter checksum calculation;
user lock.
418
97 Motor control Motor model settings. 429
98 User motor parameters Motor values supplied by the user that are used in the motor
model.
433
99 Motor data Motor configuration settings. 435
200 Safety FSO-xx settings. 442
206 I/O bus configuration
207 I/O bus service
208 I/O bus diagnostics
209 I/O bus fan identification
Distributed I/O bus settings. 442
Group Contents Page