ABB aquamaster - Replacing a Battery; Spares Kits

Electronic Commercial Water Meter
AquaMaster™ 4 Start-Up And Operation
36 IM/AM Issue 13
4.4 Replacing a Battery
Normal Operation
If both batteries are good, no battery icons are displayed.
Replace Battery
When a single, steady battery icon is shown, replace the cell on
the side indicated – in this example, the right-hand battery. Wait
approximately three seconds after disconnecting the battery
before connecting the new battery. DO NOT change a battery if its
associated icon is flashing.
Battery Pack Exhausted
Important. If both batteries require replacement, first change the
cell indicated by the steady icon – in this example, the left battery.
The flashing icon indicates the battery currently in use.
4.4.1 Spares Kits
Tran smi tter
Note. Each battery must be connected to the cable from the same side of the termination area as the
battery position in the battery holder or lid. For dual battery units, replace only the battery indicated by
the battery legend described below.
Current Model (flat cover version)
Battery Kit comprises 1 battery and one seal MEFA 9947
Lid assembly MEFA 9948
Previous Model (domed cover version)
Battery Kit comprises 1 battery and one seal MEFA 9949
Lid assembly MEFA 9950
6232709.
8
m
3
.9074
l/s
0
-
8
6232709.
.9074
m
3
l/s
0
-
8
m
3
l/s
0
-
6232709.
.9074