70
DCT880 firmware download
General
This file describes how to download firmware into the SDCS-CON-H.
Download SDCS-CON-H firmware using the Drive loader 2.x
Installation
− Double click on Drive loader 2.x
setup.exe.
− Follow the setup instructions.
− This installs the Drive loader 2.x.
Prepare firmware download
− The firmware download is setting all parameters back to default / factory. Before starting, make a
parameter backup using either the control panel or the Drive composer.
− The firmware download deletes all application programs e.g. power optimizer. Make sure that it is possible
to re-load the application programs.
− The firmware download is done via a USB port and the control panel.
Firmware download
− The drive composer is closed.
− The DCT880 is done with booting (energized, auxiliary voltage is on).
− The control panel is only connected to one DCT880.
− Open the Drive loader 2.x by double click.
Service
3ADW000449R0101 DCT880 Service Manual e a
To Next Page
Loading...
