ABB DPA UPScale ST60 - JD1; RS232 Smart Port Computer Interface; USB Computer Interface

Modifications reserved
Page 50/79
6.4.2 JD1 / RS232 smart port computer interface
The
Computer Interface JD1
(4) located on the distribution part is an intelligent RS232 serial port that
allows the UPS to be connected to a computer. The connector JD1 is a standard D-Type, 9-pin,
female.
The optional WAVEMON software allows the computer to monitor the mains voltage and the UPS
status continuously.
In the event of any changes, the computer terminal will display a message.
(For details see ABB’s optional monitoring package: WAVEMON).
6.4.3 USB computer interface
The
Computer Interface USB
(5) is located on the distribution part and is in parallel with the
intelligent RS232 serial port
JD1
.
The optional WAVEMON software allows the computer to monitor the mains voltage and the UPS
status continuously.
In the event of any changes, the computer terminal will display a message.
(For details see ABB’s optional monitoring package: WAVEMON).
Fig 6.4.3-1: Distribution Interfaces
JR2 / RS485
(Not used ) foreseen for RJ45 Plug
X2
Customer interface on Phoenix terminals
= Potential free contacts
X1
Customer inputs (detail see chapter 6.4.2 )
JD1
Smart port RS232 / sub D9/ female,
PC interface
USB
PC interface
SNMP
Slot for optional SNMP card ONLY
Modem
Slot for optional modem/ethernet card ONLY