ABB EBN853 - Factory Default; Standard Control; Profibus DP Communication

Design and function
16 OI/PME/LME/EAN823/EBN853/EBN861-EN
2.2 Factory default
The standard delivery scope includes metric cable entry threads with IP66 seal plugs. Optional
NPT and PG adapters are available.
The individual actuator configuration may vary from the standard setup above. This information
can be displayed via the user interface.
Unless otherwise specified by the user, the power electronic units are delivered with the
following standard configuration:
2.2.1 Standard control
Behavior in 0 % / 100 % end
position:
Observe rated torque/force
Setpoint function: Linear; setpoint = position value
Setpoint input: 4 ... 20 mA
Function selection: Positioner, parameter: setpoint
Positioning time-out: disabled
Actual output value: 4 ... 20 mA
Digital inputs: DI 1 Manual/Automatic switching; DI 2 / DI 3 manual
operation +/-
Digital outputs: DO 1 ready for operation, DO 2/3 end position signal
Operating range: not setup
2.2.2 Profibus DP communication
Behavior in 0 / 100 % end position: Observe rated torque/force
Setpoint function: Linear; setpoint = position value
Setpoint input: Digital
Function selection: Positioner, parameter: setpoint
Positioning loop monitoring: disabled
Actual output value: Digital
Digital output: DO 1/2 end position signal 0 % / 100 %
Operating range: not setup