Local operation
OI/PME/LME/EAN823/EBN853/EBN861-EN 27
5 Local operation
5.1 General information on operation
The basic settings "Define end positions" and "Initial diagnosis" can be configured via the
commissioning and service field (ISF). It can be used to adjust the actuator to the working area
and set the direction without using a PC. The actuator can be further parametrized using a
graphic user interface.
Important (Notice)
The commissioning and service field is located on the electronic unit.
Important (Notice)
For information about how to use an engineering or configuration software refer to the
additional documentation, see 11.1 “Other applicable documents”.
To Next Page
Loading...
