USER INTERFACE
ID Event Description
F5.171 Output voltage too low timed
The RMS value of output line voltage has fallen
below the low voltage threshold value for more than
a preset time.
F5.173 Programmed trip
The system has been deliberately tripped, as part of
a specific test routine.
F5.196 24V buffered PSU not charged timed
This event is triggered if both supplies are
indicating not charged after a specified depletion
time.
F5.201 APS enclosure temperature too high
The APS enclosure temperature is measured as
higher than allowed. This indicates compromised
cooling.
F5.205 DC insulation monitor resistance low
Monitors DC conductors for low or failed insulation
resistance.
F5.206
UPS Group Units is greater than Total
UPS Units
Detects minimum number of UPS units greater than
total number of UPS units.
F5.208 UPS Group Starting Mode timeout
UPS units are in Group Starting Mode for more than
preset time.
F5.217 Ethernet Comms internal failure Ethernet Comms internal comms failure is detected.
F5.218 Ethernet Comms external failure
Ethernet Comms external comms failure is
detected.
F5.219 Ethernet Comms IP config invalid Ethernet Comms IP configuration not valid.
F5.222 APS encl. IO Comms loss
Problem has been detected in APS enclosure IO
module or associated peripherals.
F5.223 MVM encl. IO Comms loss
Problem has been detected in MVM enclosure IO
module or associated peripherals.
F5.229 AC Zone fault detected AC Zone fault has been detected.
Table 7.4: List of Faults and description
7.1.7. Event Log
This page shows a list of the system messages for system events including origin, title, code, type,
timestamp, and basic description. The events are classified as power quality, information, warnings or
faults. Up to ten events are displayed on each page.
To Next Page
Loading...
