Need help?Do you have a question about the ABB MegaFlex UL S1 Series and is the answer not in the manual?
General guidelines for handling, lifting, and operating the UPS safely.
Instructions for safe installation, including environment and connections.
Crucial safety information for handling and disposing of batteries.
Explains the meaning of hazard and caution symbols used in the manual.
Describes the standard Voltage Frequency Independent operation mode.
Details the high-efficiency eBoost operation mode (optional).
How the UPS operates during a utility power failure.
Process of restoring normal operation after a utility failure.
Explains the automatic transfer to utility bypass during faults.
Overview of the Redundant Parallel Architecture system.
How to increase output power by paralleling units.
How to improve reliability using redundant parallel units.
Key features of the RPA Parallel System, like redundancy.
Information on how to contact ABB for technical assistance.
Detailed explanation of the LOAD PROTECTED, ALARM, and STOP OPERATION LEDs.
Alarms related to setup values, board failures, and communication channels.
Alarms related to earth leakage, ground faults, and fuse failures.
Alarms for rectifier/transformer overtemp and battery status issues.
Alarms related to inverter, bypass, drivers, and synchronization.
Alarms for overload, utility issues, fan failures, and maintenance needs.
Steps required for the initial commissioning and start-up of the UPS.
Procedure for completely powering down the UPS system.
Detailed step-by-step guide for the first start-up of a single MegaFlex unit.
Initial configuration parameters required during the first start-up.
Steps for closing the Q1 breaker and turning the inverter ON.
Initial start-up procedure when the UPS operates as a frequency converter.
Steps for closing Q1 breaker and turning the inverter ON in FC mode.
Step-by-step guide for starting up an RPA Parallel System.
Configuration settings for the power-up screen in RPA Parallel Systems.
Steps for closing Q1 breaker and turning inverters ON in RPA systems.
Important note that all maintenance must be done by ABB Service Technicians.
Importance of service checks and handling Service Check alarms.
Mandatory battery maintenance, testing, and charging recommendations.
Overview of the recommended preventive maintenance tasks.
To Next Page
General