MegaFlex 1000 to 1600 UPS User Manual / REV-A
Commands 1 screen
Allows the user to
commands.
Rectifier ON
Rectifier switching ON command.
Rectifier RESET
Rectifier restore command.
Reserved for the ABB Service Center.
Led Rectifier status
Indicates the Rectifier’s status: ON = lit OFF = turned Off
Inverter ON
Inverter switching ON command.
Note!
When eBoost™ Operation Mode
is enabled, control of Inverter status and selection of the feed
path is done autonomously by the UPS control logic.
Therefore, Inverter ON / Inverter OFF commands are disabled when eBoost™ Operation Mode
enabled.
Inverter OFF
Inverter switching OFF command.
This command is also used as EPO (Emergency Power Off) reset after the contact closing.
Note!
Inverter OFF command is disabled when eBoost™ Operation Mode is enabled.
It indicates the Inverter status:
ON / OFF / Pre-charge / Pre-charge completed / Soft-start.
To Next Page
Loading...
Need help?
General