Operation Manual / TPR56-F + TPR61-F
2 Safety / 2.9 Lifting loads
© Copyright 2018 . All rights reserved. HZTL2490_EN Revision D May 2018
2.9 Lifting loads
WARNING
Suspended loads
Loads not suspended in compliance with regulations may lead to per-
sonal injury or accidents with fatal consequences.
u Loads must always be fastened to technically perfect lifting gear
with sufficient loading capacity.
u Make sure the load is suspended properly on the crane hook.
u Do not let anyone stand beneath a suspended load.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
In the case of two or more suspension points, the slinging angle must
not exceed 45°. This avoids excessive loading due to inclined tensile
loading.
u Fasten turbocharger assemblies / components as described in re-
spective handling steps.
u Before attaching slings, allow turbocharger components to cool down
(maximum 80°C).
u Use suitable protection at sharp edges.
u Completely screw in assembly / fitting devices without fail so that
they cannot work loose during use.
u Use assembly / fitting devices only for applications described.
u Make sure removed turbocharger components stand safely and se-
curely.
Page 26 / 79
To Next Page
Loading...