Document: v0.6 / Document No.: 6AGA000008-0102-EN | Date: 22-05-2019 Page 6 of 23
1 Introduction
1.1 Preface
The HVC-C product line is the new ABB solution for Overnight Charging of Heavy Vehi-
cles. The product line allows 100kW and 150kW charging with up to 3 charging outlets
per one charger. The charging of the vehicles is done sequentially following the first
come, first serve principle.
This manual describes the general usage and daily operation instructions of the HVC-C
product family.
1.2 Intended use of this document
This document serves:
• As a reference for site operators who are responsible for the charger’s operation
on site, performing daily inspection and maintenance activities and who are able
to perform simple trouble shooting activities, after instruction of a certified ABB
technician.
• As a reference to the operator’s customers, the EV drivers who will mainly use
the pictograms and texts on the display of the charger. The user interface design
was thoroughly evaluated with user groups to optimize understandability and to
get the best user experience. Besides the screens needed for the charging pro-
cess, the interface has help screens available to provide additional information.
1.3 Intended use of the charger
The HVC-C product is a stand-alone DC high power charger for electric buses and trucks.
The outlets of the charger must not be used to charge any other equipment than electric
vehicles compatible with the supported charging standards.
To Next Page
Loading...
Need help?
General
