4 Repair
4.9.2. Repair routines
231 3HAC022032-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Replacement of air hose
The following procedure details how to replace the air hose.
F 425 mm From the Y-plug connector at axis 3 motors to the
straight fitting in the motor cover axis 3.
G 80 mm From the Y-plug connector at axis 3 to the Y-plug
connector for the balancing cylinder.
H 460 mm From the Y-plug connector for the balancing
cylinder to the elbow fitting in the bak of the
balancing cylinder, se step 7 in Replacement of air
hose on page 231.
K 220 mm From the Y-plug connector for the balancing
cylinder to the T-plug connector for axis 1 and axis
2.
L 140 mm From the T-plug connector to the straight fitting in
the motor cover axis 1.
M 365 mm From the T-plug connector to the straight fitting in
the motor cover axis 2.
N 150 mm To the Bulkhead plug in the front plate.
Pneumatic
house
Article number
3HAC026526-001
Note
Action Note/Illustration
1. -The air is let in via the cover of the rear side
of the foot where a bulkhead plug for Ø6mm
plastic hose is mounted.
-A Plastic hose is drawn from the bulkhead
plug to a T-plug connector and led to the
SMB-compartment.
xx0600003116
2. The hose is drawn through a drilled hole in
the rubber sealing and firmly tightened with a
straight fitting.
xx0600003117
Continued
Continues on next page
To Next Page
Loading...
