NoteAction
Other design than Type C:Refit the base with its attachment screws
and washers.
Note
The attachment screws on Type C are dif-
ferent from the ones on Other design than
Type C!
7
Tightening torque: 35 Nm.
xx0800000357
Type C:
Tightening torque: 110 Nm.
xx1200000634
Parts:
• A: Gearbox axis 1
• B: Base
• C: Other design than Type C: At-
tachment screws M8x40 quality
Steel 12.9 Gleitmo and washers
(24+24 pcs)
• C: Type C: Attachment screws
M12x50 quality Steel 12.9 Gleitmo
and washers (24+24 pcs)
• D: O-ring (Not visible behind cover
plate in figure of Type C)
• E: Cover plate
• F: Attachment screws M6x16 qual-
ity 8.8-A2F (5 pcs)
Apply some grease to the o-ring and refit
the o-ring between the cover and base.
8
Refit the cover plate at the bottom of the
base with its attachment screws.
9
Continues on next page
240 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
4 Repair
4.3.5 Replacing the base
Continued
To Next Page
Loading...
