3 Maintenance
3.4.7. Oil change, gearbox axis 6
1713HAC026876-001 Revision: C
© Copyright 2006-2008 ABB. All rights reserved.
Filling, oil, axis 6
The procedure below details how to fil oil in the gearbox, axis 6.
When using the oil exchange equipment, follow the instructions enclosed with the kit. Art.
no. for the kit is specified in Required equipment on page 169.
Action Note
1.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
2.
WARNING!
Handling gearbox oil involves several safety risks.
Before proceeding, please observe the safety
information in section WARNING - Safety risks
during work with gearbox oil on page 36.
3. Remove the oil plug, filling. Shown in the figure Location of
gearbox on page 169.
4. Refill the gearbox with lubricating oil.
The amount of oil to be refilled depends on the
amount previously being drained. The correct oil
level is detailed in section Inspection, oil level
gearbox axis 6 on page 125.
Art. no. and the total amount are
specified in Required equipment
on page 169.
5.
NOTE!
Don´t mix Kyodo Yushi TMO 150 with other oil types!
Detailed in section Oil in
gearboxes.
6. Refit the oil plug. Tightening torque: 24 Nm.
Continued
To Next Page
Loading...
