4 Repair
4.4.1. Replacement of turning disk
2513HAC026876-001 Revision: C
© Copyright 2006-2008 ABB. All rights reserved.
2. Secure the turning disk with its attachment
screws.
12 pcs, M12 x 30, 12.9 quality
UNBRAKO, tightening torque: 100 Nm.
Reused screws may be used, providing
they are lubricated as detailed in
section Screw joints on page 390
before fitting.
3. Perform a leak-down test of the gearbox axis 6. Detailed in section Performing a leak-
down test on page 188.
4. Refill the gearbox 6 with oil. Detailed in section Oil change, gearbox
axis 6 on page 169.
5. Refit any equipment removed during disassem-
bly, to the turning disk.
6.
DANGER!
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in section DANGER - First test
run may cause injury or damage! on page 33.
Action Note
Continued
To Next Page
Loading...
