2 Installation and commissioning
2.5.9. Installation of cooling fan for motors, axes 1 and 2 (option)
3HAC026876-001 Revision: C86
© Copyright 2006-2008 ABB. All rights reserved.
Cooling fan
The details of the cooling fan are shown in the figure below.
xx0500002158
Required equipment
A Fanbox
B Attachment screws, fanbox plates (9 pcs)
C Groove in the connector
D Tightening screws, fanbox (3 pcs)
Equipment Art. no. Note
Cooling fan 3HAC15374-1
Cabling, cooling fans, axes
1 or 2.
3HAC023599-001 Choose this cabling if equipping the
robot with cooling fans on axis 1 or 2 .
Plate for customer
connections
3HAC025778-001 An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page 87.
Additional cabling to and
inside the controller
-
Material set fan axes 1 and
2
3HAC023999-001
Cable harness inside
controller
3HAC025488-001
Locking liquid - Loctite 243. Used for the three tightening
screws.
Continued
Continues on next page
To Next Page
Loading...
