Specification of Variants and Options
Product Specification S4Cplus M2000/BaseWare OS 4.0 43
No cabling from the drive unit U to cabinet wall is included.
For IRB 6400R
the option consists of a DC link DC4U with integrated U drive unit
with cabling to the cabinet wall.
393 Drive unit GT
A separate drive unit including two drives. Recommended motor type see Figure 23.
Not available for IRB 4400, 6400R, 6400S
396 Prepared for drives GT
The same as 393 but without the GT drive module. The preparation includes; larger
transformer, larger DC link DC2, and one additional axis computer with its connection
board.
Not available for IRB 4400, 640, 6400R, 6400S
398 Prepared for drives GT
The same as 396 but without additional axes computer
and connection board.
399 Prepared for drives GU
The same as 396 but intended for a GU drive module. The preparation includes: larger
transformer, larger DC link DC4, and one additional axis computer with its connection
board.
Not available for IRB 4400, 640, 6400R, 6400S.
394 Drive unit T+GT
A combination of 392 and 393.
Not available for IRB 4400, 640, 6400R, 6400S
395 Drive unit C+GT
A combination of 391 and 393
Not available for IRB 4400, 640, 6400R, 6400S
365 Trackmotion
A special wiring for the three motor combination 394 (IRB 140, 1400, 2400 only) to
be used when axis 7 is intended for an ABB Trackmotion. The drive unit in the
DC link and the Trackmotion measurement board is then connected to the robot axes
computer 1 while the drive unit and the measurement board for motor 8 and 9 is
connected to axes computer 2. All motor power wiring is routed to one common
connector, XS7.
701-706 Servo gun interfacing (IRB 6400R, IRB 6600 and 7600)
For further information see the Product Specification IRB 6400R chapter Servo Gun
or IRB 6600 chapter Servo Gun (overview), and the Product Specification RobotWare
Options (function description).
701 Stationary gun (SG)
IRB 6400R
The option consists of an encapsulated Serial Measurement Board (SMB) and cabling
inside the controller.
The cabling between SMB and the controller is selected in the option range 686-
689.
Drive unit 397 is required.
IRB 6600/7600
The option includes cabling inside the controller and the manipulator, and a 7m
resolver cable between the manipulator and the welding gun pedestal. The customer
connector to this cable should be an 8-pin Burndy, wired according to Motor Unit
To Next Page
Loading...
