Specification of Variants and Options
44 Product Specification S4Cplus M2000/BaseWare OS 4.0
specification.
The cable between the controller DDU and the welding gun pedestal is selected in the
option range 686-687 (different lengths). The customer connector to this cable should
be of Industrial Multi-connector type, corresponding to the manipulator CP/CS (see
Product Specification IRB 6600/7600). Besides the necessary motor wiring, it also
contains 12 wires for gun I/O, accessible on screw terminals in the cabinet.
Drive unit 381 (DDU-V) must be selected.
702 Robot Gun (RG)
IRB 6400R
The option consists of an encapsulated SMB and cabling inside the controller.
It also includes bracket for 6400R foot mounting of the SMB box, and cabling between
the SMB box and the manipulator.
The cabling between SMB and the controller is selected in th option range 681-684.
Drive unit option 397 is required.
IRB 6600/7600
The option includes cabling inside the controller and the manipulator. The cable
between the controller and the manipulator is selected in the option range 697-699.
Besides the necessary motor wiring the cable also contains 22 wires for gun I/O and
CAN/DeviceNet fieldbus. The I/O wiring is accessible on screw terminals in the
cabinet.
Drive unit 381 (DDU-V) must be selected.
703 One SG and one RG
IRB 6400R
The option is a combination of 701 and 702. A distributed drive unit (DDU) controls
the SG motor.
The cabling between the SG SMB and the controller is selected in the option range
686-689, and the cabling between the RG SMB and the controller is selected in
the option range 681-684.
Drive unit options 397 (for the RG) and 380 (for the SG) are required.
IRB 6600/7600
The option includes cabling inside the controller and the manipulator. The cable
between the controller and the welding gun pedestal is selected in the option range
686-687. The customer connector to this cable should be of Industrial Multi-connector
type, corresponding to the manipulator CP/CS (see Product Specification IRB 6600/
7600). Besides the necessary motor wiring it also contains 12 wires for gun I/O,
accessible on screw terminals in the cabinet.
The cable between the controller and the manipulator is selected in the option range
697-699. Besides the necessary motor wiring the cable also contains 22 wires for gun
I/O and CAN/DeviceNet fieldbus.
The option also consists of an SMB box for two resolvers, a serial cable between the
box and the controller (the same length as 641-642), and two resolver cables, one 1.5m
for the RG and one 7m for the SG. The customer connector to the SG cable should be
an 8-pin Burndy, wired according to the Motor Unit specification. The SMB box
should be mounted close to the manipulator foot. Dimensions and mounting
information can be found in the Product Specification Motor Unit.
Drive unit 382 (DDU-VW) must be selected.
To Next Page
Loading...
