8 Robot controller
8.0.5 LAN Settings Window
3HAC 16245-1 A 161
8.0.5 LAN Settings Window
When is it
shown?
The LAN Settings window will be displayed when LAN Settings is pressed in the Network
Settings window as shown in the figure in section "Network Settings".
en0100000256
Node
identification
Configure for
fixed IP network
1. Press FIX IP .
2. Fill in the assigned IP address for the Main Computer, and the Subnet Mask and
Gatway for the Network and press OK .
You will be asked to reboot the system.
3. Press YES to make the new setting take effect.
Configure for
DHCP distributed
IP network
1. Press DHCP .
2. The value for IP will change to DHCP.
3. Press OK.
You will be asked to reboot the system.
4. Press YES to make the new setting take effect.
NONE will, after the system is rebooted, remove the IP settings.
CANCEL returns to the Start window, as shown in the figure in section "Start Win-
dow", without changing any settings.
Parameter Type Description
MAC ID Node identification The Main Computer’s ethernet address.
Current IP Node identification The Main Computer’s current IP address. This row
is blank if the LAN Settings has not been defined.
IP Network setting Space for typing a new IP address, for the Main
Computer or the DHCP server. See Configure for
fixed IP network and Configure for DHCP distrib-
uted IP network below.
(Subnet mask) Network setting Shows the subnet mask of the network.
Only visible when configured for fixed IP.
(Gateway) Network setting Shows the gateway IP for the network.
Only visible when configured for fixed IP.
To Next Page
Loading...
