8 Robot controller
8.0.6 Service Settings Window
162 A 3HAC 16245-1
8.0.6 Service Settings Window
When is it
shown?
The Service Settings window will be displayed when Service Settings is pressed in the Net-
work Settings window as shown in the figure in section "Network Settings".
en0100000257
Service Setting
OK returns to the Start window as shown in the figure in section "Start Win-
dow".
Parameter Description
IP (service setting) The IP Address for the I/O Computer
IP Required to configure your PC’s network settings for
communication between RobInstall and the I/O Computer.
Subnet mask Required to configure your PC’s network settings for
communication between RobInstall and the I/O Computer.
Gateway Required to configure your PC’s network settings for
communication between RobInstall and the I/O Computer.
To Next Page
Loading...
