Specification of Variants and Options
72 Product Specification IRB 6600 M2000
Connection to
056 Manipulator
The signals are connected directly to the manipulator base to one heavy duty industrial
housing with a Harting modular connector R1.CP/CS see Figure 41 and Figure 43).
The cables from the manipulator base are not supplied.
057 Cabinet
The signals CP/CS are connected to 12-pole screw terminals, Phoenix
MSTB 2.5/12-ST-5.08, in the controller.
The cable between R1.CP/CS and the controller is supplied.
For information about the limited number of signals available,
see chapter 1.9.2 DressPack options.
Connection to cabinet (Cable lengths)
Parallel/CANDeviceNet/Interbus/Profibus
675/660/670/665 7m
676/661/671/666 15m
678/663/673/668 30m
Robot Servo Gun Extended/Stationary Servo Gun
699/686 7m
697/687 15m
698/689 30m
EQUIPMENT
691 Safety lamp
A safety lamp with an orange fixed light can be mounted on the manipulator.
The lamp is active in MOTORS ON mode.
The safety lamp is required on a UL/UR approved robot.
092 Fork lift device
Lifting device on the manipulator for fork-lift handling.
Note. When Cooling Fan for axis 1 motor unit is used, this must be disassembled in order
to use fork lift device.
087 Base plate
Can also be used for IRB 7600. See chapter 1.3 Installation, for dimension drawing.
091 Brake release cover
A cover for the break release buttons.
113 Cooling fan for axis 1 motor (IP 54)
Cannot be combined with Cooling fan for axis 2 motor option 114.
For in use recommendations see 1.7 Cooling fan for axis 1-3 motor (option 113-115).
See Figure 44.
Not for protection Foundry.
To Next Page
Loading...
