OI-LLT100-EN Rev. D | User Guide 45
Table 4 Errors
# Error message Action
0 Level Sensor Failure Contact ABB service for replacement.
1 Temperature Sensor Failure Contact ABB service for replacement.
2 Illegal Memory Access Reset device. Contact ABB if condition persists.
3 Safety Function Flow Failure Reset device. Contact ABB if condition persists.
4 Level Sensor Out of Limits Check for level sensor failure.
5 Temperature Sensor Out of Limits Check for temperature sensor failure.
6 Self-Test Failure. Reset device Contact ABB if condition persists.
10 Level Sensor. Out of Range Check process.
16 Sensor board failure Contact ABB service for replacement.
17 Sensor Board Memory Failure Reset device. Contact ABB if condition persists.
18 Sensor Board NV Write Error Reset device. Contact ABB if condition persists.
19 Device Reset Required Cycle power for changes to take effect.
20 Sensor Communication Failure Reset device. Contact ABB if condition persists.
23 Electronics NV Failure Contact ABB service.
25 Electronics NV Syncing Information Contact ABB service.
30 HMI Validation Test Failure Reset device Replace LCD if condition persists.
31 Sensor Window Obstructed/Dirty Clean window. Contact ABB if condition persists.
32 Electronics Insuff Input Voltage Insufficient voltage to operate device.
33 Amb. Temp Out of Range Readings may be invalid due to improper ambient temperature. Correct ambient temperature.
36 Data Simulation Warning One or more process values are in SIM mode.
37 Alarm Simulation Warning One or more alarms are in simulation mode.
38 Current Output in Fixed Mode Process should be in manual control mode.
39 Primary Current Uncertain Contact ABB support if condition persists.
40 Electronics ROM Failure Contact ABB support if condition persists.
41 Electronics RAM Failure Contact ABB support if condition persists.
42 Target lost Error Check Process conditions.
43 Primary Current Saturated Contact ABB support if condition persists.
44 Current Output Failure Contact ABB support if condition persists.
45 Process Media Warning Monitor Process Conditions.
46 Process Media Alarm Monitor Process Conditions.
47 Invalid algorithm parameter Adjust configured Parameters.
To Next Page
Loading...
