Chapter 5 – Programming
NCAN-02 Installation and Start-up Guide 5-5
Control Locations
ABB drives can receive control information from multiple sources
including digital inputs, analogue inputs, the drive control panel and a
communication module (e.g. NCAN-02). ABB drives allow the user to
separately determine the source for each type of control information
(Start, Stop, Direction, Reference, Fault Reset, etc.). In order to give
the fieldbus master station the most complete control over the drive,
the communication module must be selected as source for this
information. See the user documentation of the drive for information on
the selection parameters.
To Next Page
Loading...
