ABB NE840 - Getting Started; Configuration

Section 2 Interface specications
Getting Started
This product runs ABB Network Equipment Operating System (NEOS) which
provides several management tools that can be used for conguration of the unit.
NeCo - is a Network conguration management tool (NCM) made for
commissioning and maintenance of components in a network.
Web - Conguration of the unit using the web browser.
CLI - Conguration of the unit via the Command Line Interface.
If the computer is located in the same subnet as the switch you can easily use a
web browser to congure the unit. Within the web you can congure most of the
available functions.
For advanced network settings and more diagnostic information, please use the CLI.
Detailed documentation is available in the chapter The Command Line
Management Tool in the NEOS User Manual.
Factory default:
– IP address: 172.16.5.245
– Netmask: 255.255.252.0
– Gateway: Disabled
Consult your network administrator to know more on subnet.
Conguration
Congure the unit via Web browser. The unit can easily be congured through a
Web browser. Open the link http://172.16.5.245 in your web browser, and you will
be prompted with a Login screen, where the default settings for Username and
Password are:
– Username: admin
– Password: CS4dmin
3BSE080639 23