Operation Manual / Power2 340-H / Low-pressure stage
9 Disassembly and assembly / 9.15 Installing the cartridge group
© Copyright 2022 ABB. All rights reserved. HZTL4053_EN Rev.F March 2022
9.15 Installing the cartridge group
Lifting the cartridge group and rotating it by 90°
Fig.36: Lifting the cartridge group and rotating it by 90°
1. Loosen and remove nuts.
2. Lift the cartridge group out of the service support(90012).
3. Insert the screws of the service support from above and fit ring nuts(VRM) with washers.
4. Attach lifting gear to the ring nuts(VRM).
5. Lift cartridge group at the side of the ring nuts(VRM) and turn it into a vertical position.
Page 83 / 122
To Next Page
Loading...
