ABB Power2 340-H44 - Fig. 39: Installing the Compressor Casing; Table 47: Tightening Torque (72011)

Operation Manual / Power2 340-H / Low-pressure stage
9 Disassembly and assembly / 9.16 Installing the compressor casing
© Copyright 2022 ABB. All rights reserved. HZTL4053_EN Rev.F March 2022
Installing the compressor casing
Fig.39: Installing the compressor casing
*) In some installations a special graphite cord sealing(42126) is fitted instead of the O-
ring(42012) (see Spare parts →100).
Product Size Tightening torque [Nm]
Power2 340-H LP M12 105
Table47: Tightening torque (72011)
1. Fit a new, high temperature-resisting O-ring(42012, red or green).
2. Thoroughly clean the fastening strips(72012) before assembly.
3. Attach swivel lifting eyes(01) to the compressor casing(72000) and lifting gear.
4. Install the compressor casing(72000).
5. Fit the fastening strips(72012) with screws(72011).
Page 86 / 122