ABB PowerWave 33 Series 3 - Customer Inputs; Customer Outputs (OPTIONAL USB Port & Relay Card)

Modifications reserved
Page 22/50
5.1.1 Customer inputs
The customer input interfaces are standard for each model and are located in the front bottom part of
the unit.
All voltage free contacts are rated 60 VAC max. and 500 mA max.:
All the interfaces are connected to Phoenix Spring terminals with wires : 0.5 mm
2
Table 8: details of the customer inputs.
Block
Terminal
Contact
Signal
Function
X1
X1 / 10
GND
GND
12 Vdc source
X1 / 9 IN
+12Vdc
(Max 200mA load)
X1 / 8
GND
GND
Remote Shut down
X1 / 7 IN
+12Vdc
(Do not remove the factory mounted bridge until an external remote shut down is connected)
X1 / 6
GND
GND
Temperature Battery
X1 / 5
IN
+3.3Vdc
(If connected, the battery charger current is batt. temperature dependent)
X1 / 4 GND
GND
Customer IN 1
X1 / 3
IN
+12Vdc
(Function on request, to be defined)
X1 / 2
GND
GND
GEN_OPERATION
X1 / 1
IN
+12Vdc
(NC = Generator ON)
5.1.2 Customer outputs (OPTIONAL USB port & Relay card)
The customer output interfaces are on an optional relay card which goes into slot 2 of the UPS.
All voltage free contacts are rated 60 VAC max. and 500 mA max.:
All the interfaces are connected to Phoenix Spring terminals with wires: 0.5 mm
2
Table 9: details of the customer outputs + USB on the relay card.
Block
Terminal Contact
Signal
On Display Function
X2
X2 / 15
C
COMMON_ALARM
Common
X2 / 14
NC
ALARM
NO Alarm Condition
X2 / 13
NO
Common Alarm
(System)
X2 / 12
C
LOAD_ON_MAINS
Common
X2 / 11
NC
Message
(Load on Inverter)
X2 / 10
NO
Load on bypass (Mains)
X2 / 9
C
BATT_LOW
Common
X2 / 8
NC
ALARM
Battery OK
X2 / 7
NO
Battery Low
X2 / 6
C
LOAD_ON_INV
Common
X2 / 5
NC
Message
(Load on Mains bypass)
X2 / 4
NO
Load on Inverter
X2 / 3
C
MAINS_OK
Common
X2 / 2
NC
ALARM
Mains Failure
X2 /1
NO
Mains Present
+ USB
1
15