ingle UPS. The system consists only of one UPS.
arallel UPS in a Multi- UPS system and 01 stands for the first UPS
(
) in the parallel UPS system.
arallel UPS in a Multi- UPS system and 02 stands for the second UPS
(
) in the Multi- UPS system.
arallel UPS in a Multi- UPS system and 03 stands for the third UPS
(
) in the Multi- UPS system.
The definition of the UPS “Position” in a parallel system is achieved in the Menu Set-Up Service.
SYSTEM CONFIGURATION
SINGLE
Parallel System e.g. first UPS cabinet
SYSTEM CONFIGURATION
PARALLEL
Parallel System e.g. second UPS cabinet / Slave
Note: The max no. of UPS units is 10.
6.3.4 Main menu screen
Logging Control. A log of the last 99 events is stored in the
Power Management Display.
In Menu Measurements: monitor voltages, power,
frequencies, currents, autonomy etc.
The Command Menu enables to perform the commands
“Load to inverter”, Load to bypass, battery test.
The UPS Data are the UPS personalized information “serial
number”
Various settings can be performed by the user: Date/Time,
automatic battery test, etc.
SET-UP USER
SET-UP SERVICE
Various adjustments can be performed by the service staff
SET-UP SERVICE
NO MORE MENU
Logging Control; a log of the last 99 events is stored in the
Power Management Display.
01 05-10-08
LOCAL LOAD OFF
Every stored event is identified with a sequential number and
time stamp.
02 05-10-08
LOCAL LOAD TO BYP
By press ENTER the code of the event will be displayed. (Press
ENTER to come back to the previous indication)
03 8104
LOCAL LOAD TO INV
All events and alarms are indicated with their date and time of
04 05-10-08
LOCAL LOAD TO INV
To Next Page
Loading...
