ABB PST210 - Page 59

7:2.6 Service Settings
The service setting menu consists of parameters used for maintenance and repair. This
menu should only be used by authorized service personnel.
!
Warning!
If parameters are changed, the softstarter can be damaged or malfunction. The
warranty will be void if these parameters are changed without factory authoriza-
tion.
7:2.7 All Settings
The All setting menu consists of all the available settings. Each parameter can be
adjusted separately within this menu. For a detailed description of each parameter, see
Chapter 10 “ Functions” .
Enter the All settings
Enter the menu by selecting
All Settings.
7:2.7.1 Changed Settings
The Changed settings menu consists of the parameters that have been changed in
contrast to the factory default setting. If no parameters have been changed, the LCD will
display No Changed Settings.
Figure 33: Service Settings menu
(for authorized personnel only)
Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Figure 34: All Settings menu
Chapter 7
Settings and conguration
Figure 35: Changed Settings menu
Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Low Voltage Products & Systems 7.21
ABB Inc. • 888-385-1221 • www.abb-control.com 1SXU 132 021 M0201
7