6.2 Local control from keypad
CAUTION
When you switch from local control to remote
control the setting will apply immediately. If the
remote setting has direct motor start it could start
the motor automatically and lead to personnel
injury.
When you switch from remote control to Local
control the softstarter remains in present state
when control is changed to local control.
This chapter describes how the Local control interface
works. The Local control is used to start and stop the
motor from the keypad. When Local control is selected,
the softstarter can only be controlled by the keypad.
Local control is listed below:
Table 3 Local control from keypad
Function Description
Start/stop Start and stop the motor with the
keypad.
R\L Switch between local and remote
control
Motor Jog * Run the motor as long as Jog is
pressed.
* For intormation about Motor jog see chapter 6.2.4 Motor jog.
To reach the Motor Jog, follow this path in menu:
Menu u Motor jog
6.2.1 Start key
The start key is the start switch for the softstarter.
By pressing this key the motor will start and operate
according to the set parameters. See
1
in Figure 52.
6.2.2 Stop key
The stop key is the stop switch for the softstarter.
By pressing this key the motor will stop according to set
parameters. It is possible to press stop command during
the start ramp if required. See
2
in Figure 52.
6.2.3 R\L-key
R\L-key stands for Remote or Local control.
This key gives you the option to control the softstarter
remote from digital input, fieldbus or local from the HMI.
See
3
in Figure 52.
Figure 52: Local control
PSTX
L
100-250V
50/60 Hz K4 K4 K4
StartStopReset In1In2 DGND DND +24V GND
N
52
Options Menu
1SFC132081M0201
3
2
1
4
1
Start
Options Menu
3
2
1
4
1
4
Stop
6
To Next Page
Loading...
