27
EN
LED status Operating state
green:
yellow:
red:
Indicates that a leakage to earth from the PV generator has been detected, causing the inverter to disconnect
from the grid.
green:
yellow:
red:
Indicates ananomaly in the operation of the internal ventilation system that could limit output power at high am-
bient temperatures.
Indicates that any class II overvoltage surge arresters installed on the AC or DC side have been triggered
Indicates an operating anomaly in the internal memory on which the inverter statistics are stored
The buffer battery is low and the inverter does not maintain the time setting
green:
yellow:
red:
The commissioning of the inverter must be completed through the Installation wizard steps (Web User Interface)
or using the ABB Installer for Solar Inverters mobile APP
Initial configuration failure
The inverter is in locked state due to a failure in the initial configuration of the equipment, such as the standard
network setting for the country of installation
Self-test operation failure
The firmware versions of the various devices comprising the equipment are incompatible and are being updated
(this is an automatic operation)
green:
yellow:
red:
Updating the firmware from an SD card
The equipment firmware is being updated from an SD card
green:
yellow:
red:
Updating the firmware from an SD card has failed
The equipment firmware update from an SD card has failed
green:
yellow:
red:
Updating the firmware from an SD card completed
The equipment firmware ha-successfully updated from an SD card
green:
yellow:
red:
The Remote Off command has been activated.
The unit will not connect to the network until the remote ON command has been activated
The following table shows all the possible status of “WLAN/LAN” LED on the LED panel (08) according to the operating status of
the wireless or ethernet communication lines.
LED status Operating state
Blue:
Blue: Scanning for available wireless networks.
Blue:
Blue: Wireless or ethernet network is connected to the inverter and IP address is obtained.